Carpet Cleaning Spotting Guide for San Diego Ca
By Rug Rats and Peninsula Carpet Care
List of Steps
Step 1: Unknown and greasy spots.Remove as much of the foreign material as possible by blotting with a white paper towel or scraping with a dull knife. Apply isopropyl rubbing alcohol to a clean white cloth, white paper towel or cotton ball. If the spot extends deep into the pile use a blotting motion until the spot is removed or no color is transferred to the cloth. Do not allow the alcohol to penetrate into the backing as this will destroy the latex bond. If the spot is on the surface only, rub in one direction at a time. Never use a circular motion to remove spot as this may destroy the texture. Stop if spot is removed. If not, go to step 3.Step 2: Water based spots.Blot up as much of the spill as is possible. A wet vacuum is useful if a large quantity of liquid was spilled. If spot has dried, saturate the tufts in the affected area with tap water (do not overwet). Allow to remain for about 1 minute and blot. If the spot is being removed using water, continue until the spot is completely removed. Blot dry and apply the paper towels and brick. If it is not completely removed go to step 3.Step 3: Remove as much of the foreign material as possible by blotting with a white paper towel or scraping with a dull knife. Apply a small quantity of detergent solution to the spot. Use a blotting motion to work the detergent into the affected area. If spot is being removed continue applying detergent and blotting with a white paper towel until spot is removed. Rinse with tap water using a spray bottle, blot to remove excess moisture, spray lightly with water, do not blot this time; apply pad of paper towels and brick and allow to dry. If there is still some stain on the carpet and blotting is not removing it, then moisten the tufts in the stained area with 3% hydrogen peroxide. Let stand for one (1) hour. Blot and repeat until carpet is stain free. Light will cause peroxide to change back to water so no rinsing is necessary. Apply pad of paper towels and weight down with brick.A. Blood, catsup, cheese, chocolate, cough syrup, mixed drinks, soft drinks, soy sauce, starch, toothpaste, water color and white glue.Blot with white paper towel to remove as much of the stain as possible then neutralize with an ammonia solution. Saturate spot using spray bottle. Do not wet backing. Blot with a white paper towel to remove excess moisture. After neutralizing begin with step 3 of general procedure. All solutions for removing blood must be cool.B. Beer, coffee, perfume, tea and wine.Blot with a white paper towel to remove as much of the stain as possible then neutralize with the white vinegar solution. Saturate spot, using a spray bottle and blot to remove excess moisture. After neutralizing go to step 3 of general procedure.C. Egg, excrement, urine and vomit.Remove as much of the stain as possible by using a spoon or dull knife. Blot up as much of the stain as possible, then neutralize by spraying the affected area with the ammonia solution. Care should be taken to remove all protein matter. Blot to remove excess moisture and go to step 3 of general procedure.D. Candle wax or other types of wax.Spread brown paper (such as grocery bag) or a terry cloth towel over the area and iron with the setting on "warm." The wax will be absorbed into the paper or towel. Remove any traces with alcohol or dry cleaning fluid.E. Chewing gum.Freeze the gum using an ice cube. Shatter the frozen gum with a knife handle and vacuum. Some citrus based products such as De-Solv-It* by Orange-Sol have been demonstrated to break down the sticki- ness of gum so that it can be removed.*De-Solv-It is a registered trademark of Orange-Sol F. Mud. Allow mud to dry completely. Shatter the dried mud with the handle of a knife and vacuum. Go to step 3 of general procedure.G. Rust. Saturate spot with lemon juice, using a spray bottle, and allow to remain for 5 minutes. Go to step 3 of general procedure to remove lemon juice. If this does not work, and it may not, call a professional. Most rust removers contain a very strong acid and are, therefore, not recommended for use by homeowners.H. Nail Polish. Remove as much of the nail polish as possible using a spoon or dull knife. Apply a non oily nail polish remover to a clean white cloth and gently rub (in only one direction at a time) or blot the spot. Continue until spot is removed. Do not allow nail polish remover to get to the latex backing. Go to step 3 to remove nail polish remover.I. Soot, graphite, copier material. Vacuum using crevice tool of vacuum cleaner to remove the soot. If all, or most, of the soot has not been removed, call a professional cleaner. If vacuum- ing has removed all particles go to step 1 of gen- eral procedure to remove any traces.Stains That Can't Be Removed Acid toilet bowl cleaners, acne medication, alkaline drain cleaners, chlorinated bleaches, hair dyes, iodine, insecticides, mustard with tumeric, plant fer- tilizers and stains of this nature cannot be removed as they have permanently altered the carpet's color. Call a professional. Most likely the only solution is to insert carpet from a closet, or some other area into the area where the spot was cut out.